In the current limit control method, when the load current reaches a predefined lower value, then

A)
the chopper is switched on
B)
load voltage goes to zero
C)
the chopper is switched off
D)
the source voltage is removed

Correct Answer : Option (A) :   the chopper is switched on

Explanation : In CLC, when the current reaches the upper limit the chopper is switched off and current starts to decay. When current reaches a predefined lower limit, the chopper is again switched on and current starts to rise, the process is thus again repeated.

Recently Updated in Power Electronics Questions
Static UPS requires ______
A)
only rectifier
B)
only inverter
C)
both inverter and rectifier
D)
None of the above

Correct Answer :   both inverter and rectifier

Explanation : Rectifier to converter the dc from the battery to ac. Inverter to charge the battery from mains.

HVDC transmission has ___________ as compared to HVAC transmission.
A)
higher corona loss
B)
smaller transformer size
C)
smaller power transfer capabilities
D)
smaller conductor size

Correct Answer :   smaller conductor size

Explanation : The conductor size is smaller as there is no sink effect, and the whole conductor is utilized for transmitting power.

SPMS are based on the ________ principle.
A)
MOSFET
B)
Chopper
C)
Phase control
D)
Integral control

Correct Answer :   Chopper

Explanation : SMPS (Switching mode power supply) are based on the chopper principle. The output dc voltage is controlled by varying the duty cycle of the chopper circuit.

ECE MCQ's

Power Electronics
Digital Electronics
Analog Electronics
Microprocessors
Radio Receivers
Signals and Systems
Satellite Communication
Communication Systems
Microwave Communication
Automatic Control Systems
Materials and Components
More