To call a stored procedure in
HSQLDB, you can use the
CALL statement followed by the name of the stored procedure and any required parameters. Here's the basic syntax:
CALL procedure_name(parameter1, parameter2, ...);?
Replace
procedure_name with the name of the stored procedure you want to call, and provide any required parameters according to the procedure definition.
If the stored procedure returns a result set, you can use it within a
SELECT statement, similar to querying a table. Here's an example:
CALL my_stored_procedure();?
In this example, we're calling a stored procedure named
my_stored_procedure without any parameters.
If the stored procedure requires parameters, you can provide them as follows:
CALL my_stored_procedure('parameter_value');?
Replace 'parameter_value' with the actual value you want to pass to the stored procedure.
If the stored procedure returns a result set, you can use it within a
SELECT statement, similar to querying a table. Here's an example:
SELECT * FROM my_stored_procedure();?
This retrieves the result set returned by the stored procedure named
my_stored_procedure.
Make sure the stored procedure is created in the database before you attempt to call it. You can create stored procedures using the
CREATE PROCEDURE statement in
HSQLDB.
