For welding plates of thickness less than 5 mm, its edges

Mechanical Engineering : Workshop Technology - Quiz(MCQ)

should be bevelled to a single-V or U-groove

do not require bevelling

should have a double-V or U-groove on one side

should have a double-V or U-groove on both sides

Correct Answer : Option (B) : do not require bevelling

Recently Updated in Workshop Technology Questions

In __________ welding, the weld may be made either from left to right or from right to left.

fore-hand

vertical

back-hand

None of the above

Correct Answer : vertical

In a four high rolling mill, there are four rolls out of which

two are working rolls and two are backing up rolls

three are working rolls and one is backing up roll

one is working roll and three are backing up rolls

All of the above

Correct Answer : two are working rolls and two are backing up rolls

Galvanising is a

zinc diffusion process

process of coating zinc by hot dipping

process used for making thin phosphate coating on steel

None of the above

Correct Answer : process of coating zinc by hot dipping