Tandem drawing of wires and tubes is necessary because

Mechanical Engineering : Workshop Technology - Quiz(MCQ)

annealing is needed between stages

it is not possible to reduce at one stage

accuracy in dimensions is not possible otherwise

surface finish improves after every drawing stage

Correct Answer : Option (A) : annealing is needed between stages

Recently Updated in Workshop Technology Questions

In __________ welding, the weld may be made either from left to right or from right to left.

fore-hand

vertical

back-hand

None of the above

Correct Answer : vertical

In a four high rolling mill, there are four rolls out of which

two are working rolls and two are backing up rolls

three are working rolls and one is backing up roll

one is working roll and three are backing up rolls

All of the above

Correct Answer : two are working rolls and two are backing up rolls

Galvanising is a

zinc diffusion process

process of coating zinc by hot dipping

process used for making thin phosphate coating on steel

None of the above

Correct Answer : process of coating zinc by hot dipping