The area of reduced signal strength in a non directional beacon is called as ______

Aeronautical & Aerospace Engineering : Avionics - Quiz(MCQ)

Zone of silence

Cone of silence

Zero reception zone

Non radio zone

Correct Answer : Cone of silence

Explanation : The NDB works on an omnidirectional antenna which has the radio pattern of a donut. The zone on the middle which is directly above the antenna is called as the cone of silence. In this region, no signal is transmitted.

Recently Updated in Avionics Questions

Which of the following type is not used in an Omega system?

Valley span

Insulated tower

Hanging tower

Grounded tower

Correct Answer : Option (C) : Hanging tower

Explanation : Since the Omega stations transmit in very low frequencies, the antennas are the largest physical structures in the stations. Three types of antennas are employed in the Omega system: grounded tower, insulated tower, and the valley span.

_____ acts as a coarse tuning device for the antenna?

Loop

Helix

Filters

Amplifiers

Correct Answer : Option (B) : Helix

Explanation : The RF signal that is to be transmitted is transferred to the ‘Helix,’ a large helical coil that acts as a coarse tuning device for the antenna. The helix is equipped with separate taps for each signal frequency transmitted.

What type of transmission is used in Omega system?

Phase modulated wave

Continuous wave

Amplitude modulated wave

Frequency modulated wave

Correct Answer : Option (B) : Continuous wave

Explanation : At each Omega station, continuous wave signals on four common frequencies and one station unique frequency. The signal frequencies are time shared among the stations so that a given frequency is transmitted by only one station at any given time.