Which of the following are the two main characteristics of receivers? - Avionics MCQ

Aeronautical & Aerospace Engineering : Avionics - Quiz(MCQ)

Which of the following are the two main characteristics of receivers?

A)

Gain and attenuation

B)

Selectivity and sensitivity

C)

Modulation and demodulation

D)

Multiplexing and demultiplexing

Correct Answer : Selectivity and sensitivity

Explanation : A communication receiver must be able to identify and select the desired signal from thousands of others present in the frequency spectrum (selectivity) and to provide sufficient amplification to recover the modulating signal (sensitivity). A receiver with good selectivity will isolate the desired signal in the RF spectrum and eliminate or at least greatly attenuate all other signals.

Recently Updated in Avionics Questions

A special PCM system uses 16 channels of data, one whose purpose is an identification (ID) and synchronization. The sampling rate is 3.5 kHz. The word length is 6 bits. Find the serial data rate.

A)

451kHz

B)

336kHz

C)

326kHz

D)

152kHz

Correct Answer : Option (B) : 336kHz

Explaination : Serial data rate = sampling rate x no. bits/frame = 3.5 kHz x 96 = 336 kHz.

Which of the following is false with respect to PCM?

A)

Reliable

B)

Inexpensive

C)

Resistant to noise

D)

Not easily recoverable

Correct Answer : Option (D) : Not easily recoverable

Explanation : When signals have been degraded because of noise, attenuation, or distortion, all the receiver has to do is to determine whether a pulse was transmitted. Amplitude, width, frequency, phase shape, and so on do not affect reception. Thus PCM signals are easily recovered and rejuvenated, no matter what the circumstances.

Which of the following statements is true with respect to PCM?

A)

Analog data is transmitted directly

B)

Analog signal is amplified before transmission

C)

The parallel binary data is converted into serial before transmission

D)

The analog signal is converted into parallel binary data before transmission

Correct Answer : Option (C) : The parallel binary data is converted into serial before transmission

Explanation : The analog signal is converted into a digital signal. Since the converted digital signal is parallel bits of data, it has to be converted to serial before it can be multiplexed and transmitted.

Advertisement