In the current limit control method, when the load current reaches a predefined lower value, then

Electronics and Communication Engineering (ECE) : Power Electronics - Quiz(MCQ)

the chopper is switched on

load voltage goes to zero

the chopper is switched off

the source voltage is removed

Correct Answer : Option (A) : the chopper is switched on

Explanation : In CLC, when the current reaches the upper limit the chopper is switched off and current starts to decay. When current reaches a predefined lower limit, the chopper is again switched on and current starts to rise, the process is thus again repeated.

Recently Updated in Power Electronics Questions

Static UPS requires ______

only rectifier

only inverter

both inverter and rectifier

None of the above

Correct Answer : both inverter and rectifier

Explanation : Rectifier to converter the dc from the battery to ac. Inverter to charge the battery from mains.

HVDC transmission has ___________ as compared to HVAC transmission.

higher corona loss

smaller transformer size

smaller power transfer capabilities

smaller conductor size

Correct Answer : smaller conductor size

Explanation : The conductor size is smaller as there is no sink effect, and the whole conductor is utilized for transmitting power.

SPMS are based on the ________ principle.

MOSFET

Chopper

Phase control

Integral control

Correct Answer : Chopper

Explanation : SMPS (Switching mode power supply) are based on the chopper principle. The output dc voltage is controlled by varying the duty cycle of the chopper circuit.

ECE MCQ's

Satellite Communication

Communication Systems

Microwave Communication

Automatic Control Systems

Materials and Components