The mode that is programmed using end interrupt/error mode set command is

Electronics and Communication Engineering (ECE) : Microprocessors - Quiz(MCQ)

The mode that is programmed using "end interrupt/error mode set command" is

scanned keyboard special error mode

sensor matrix mode

scanned keyboard with N-key rollover

scanned keyboard mode with 2 key lockout

Correct Answer : Option (A) : scanned keyboard special error mode

Explanation : The scanned keyboard special error mode is programmed using end interrupt/error mode set command. This mode is valid only under the N-key rollover mode.

Recently Updated in Microprocessors Questions

If I = J = K = 13, then in Fortran 1 = 10 - (1 / 10) * 10 + (J / 5) * 4 + K ** (- 2) is equal to

Correct Answer : 8

In the dimension statement DIMENSION A (50, 50), K (100, 100) the total number of locations reserved will be

2500

100000

125000

250000

Correct Answer : 125000

In super computers the extra level of primary memory is generally called

Single stage device

Digital state device

Solid state device

Surface stage device

Correct Answer : Solid state device

ECE MCQ's

Satellite Communication

Communication Systems

Microwave Communication

Automatic Control Systems

Materials and Components