The IPX delay number command will allow an administrator to change the default settings. What are the default settings?

Networking - Quiz(MCQ)

The "IPX delay number" command will allow an administrator to change the default settings. What are the default settings?

For LAN interfaces, six ticks; for WAN interfaces, one tick

For LAN interfaces, zero ticks; for WAN interfaces, five ticks

For LAN interfaces, one tick; for WAN interfaces, six ticks

For LAN interfaces, five ticks; for WAN interfaces, zero Ticks

Correct Answer : For LAN interfaces, one tick; for WAN interfaces, six ticks

Explanation : Tick is basically the update rate of clients in the network. The IPX delay number will give the ticks at a certain time. The default ticks are–for LAN interfaces, one tick, and for WAN interfaces, six ticks.

Recently Updated in Networking Questions

EIGRP uses the ____________ algorithm for finding shortest path.

DUAL

SPF

Linkstat

Djikstraâ€™s

Correct Answer : DUAL

Explanation : EIGRP uses the DUAL algorithm for finding shortest path. DUAL stands for diffusing update algorithm and it is used to prevent routing loops by recalculating routes globally.

Administrative distance for external EIGRP route is _______

100

170

135

190

Correct Answer : 170

Explanation : Routers use the metric of administrative distance to select the best path when there are different routes to the same destination from two different routing protocols as it is a measure of reliability of routing protocols. Administrative distance for external EIGRP is 170.

For default gateway, which of following commands will you use on a Cisco router?

Default network

IP default route

IP default network

IP default gateway

Correct Answer : IP default network

Explanation : IP default network command is used to find the default gateway in Cisco router. If the router finds routes to the node, it considers the routes to that node for installation as the gateway to it.